Fault description:
Blackberry 9300 sometime had a strange problem that we can’t see display light on LCD. This problem occurs due to problem in LCD or sometime in LCD IC and track missing from display transistor to LCD connector.
Fault solution:
For this problem we have to use hardware methods for quick solution. So apply these steps one by one:
1. First change new lcd an then check light
2. If no solution then we have to use hardware technique as step 3
3. Open mobile PCB and check line continuity from LCD connector second point to display transistor IC as shown with yellow line in image below. If line missing there then apply jumper shown below:
4. After this check line from first point of LCD connector to resistance as shown in image with red line and if line missing there then apply jumper as shown in image in red line.
After applying both jumpers we will see proper display light on LCD without any problem.
Conclusion:
During new LCD change process we should use new and original LCD because local LCD can cause bad result in light.
5 comments:
You have guide very well about the how to make your display light visible. This post is well prepared for the mobile user and they can find the answer of their question, hot to solve it.
boost mobile phone signal
Really nice....I gave my Nokia 3500 classic mobile for repairing but kept the memory card with me. After repair, on inserting the card, it was asking for a password in spite of the fact that i have never set any password. Now, please help me to recover or to remove the password as i have very important data in my memory card.
iPhone Repair Dallas
your information guide me very well. i have another site to help every person. contact us http://www.mobiletechxpress.com/
nice blogs.
prepaid sim Post announcement of much awaited spectrum-sharing policy, Videocon Telecom plans to pool spectrum with other operators to provide 4G LTE services
Nice blogs,
http://bit.ly/2dOq6CG
Post a Comment